USB printers and the print app
Print from zrsPOS Print on a USB printer plugged into the tablet, or on a printer that charges the tablet.
For an ordinary USB receipt printer, a PrintBox is the better choice: the tablet keeps its USB port and its charger. Use the print app over USB when the printer must hang off the tablet itself, or when it powers the tablet.
A USB printer plugged into the tablet
An Epson TM-m30, TM-T20 or TM-T88, or any 58/80 mm printer of the USB printer class. The printer needs its own mains power; the tablet only carries the data.
- The cable. The printer has a USB-B socket. From a tablet with USB-C, use a USB-C-to-USB-B cable, or a USB-C OTG adapter and a standard printer cable. From a SUNMI with USB-A, a plain A-to-B cable.
- Plug it in and switch it on. Android asks Open zrsPOS Print when this USB device is connected?: tick Use by default and allow. Android remembers it across reboots and re-plugs.
- The printer appears in the app's list within seconds and in zrsPOS by itself. Press Local test print, then Print a test on … on the printer's page in zrsPOS.
A USB printer cannot tell its paper width; it is registered as 80 mm. For a 58 mm printer, set Paper width on its page in zrsPOS.
A printer that charges the tablet
Some receipt printers have a USB port for tablets and power the tablet through it: an Epson TM-m30II-SL in a tablet stand, for example. Android sees it as a USB accessory rather than a printer. zrsPOS Print 1.0.8 or later prints on it.
- Connect the tablet to the printer's tablet port and switch the printer on. The tablet starts charging.
- Android asks whether to open zrsPOS Print for this USB accessory. Allow it, and tick Always (or Use by default) if offered.
- The printer appears in the app's list. Press Local test print, then Print a test on … on the printer's page in zrsPOS.
Edge cases
- The tablet does not charge while an ordinary printer sits on its only USB-C port. For an all-day counter, use a USB-C hub with power passthrough (Samsung tablets accept a PD hub), a charging dock, a printer that charges the tablet, or a PrintBox.
- The printer was plugged in before the app was installed: open the app once; it asks the same question.
- Android offers another app (Epson's TM Assistant, say): clear that app's defaults in Android's settings, unplug, plug in again and choose zrsPOS Print.
- Only one app can use the printer over this cable. If Shopify POS must also print on it, give Shopify the printer's network connection.
- An Epson is not found though cable and power are fine: its USB mode may be set to Epson's vendor class. zrsPOS Print accepts both modes, but very old firmware exposes neither. Epson's TM Utility app shows and changes the setting.
- No printer found: check the cable, the printer's power and the USB permission.
More in Printing
- Choose how to print
- Who prints?
- Set up a PrintBox
- The PrintBox's status page
- Swap or add a printer on a PrintBox
- Move, unlink or reset a PrintBox
- Set up the print app
- Printers the print app can use
- Keep the print app running
- An Epson that fetches receipts
- Add a printer
- A printer's page
- Printers and their status
- Receipts by e-mail
- Gift receipts
- Nothing prints: what to check